This page was exported from Easily Pass By Training Lead2pass Latest Dumps [ https://www.freebraindump.com ] Export date:Fri Mar 29 16:00:50 2024 / +0000 GMT ___________________________________________________ Title: [Lead2pass New] 2017 Lead2pass New Updated 300-101 Exam Questions (341-360) --------------------------------------------------- 2017 October Cisco Official New Released 300-101 Dumps in Lead2pass.com! 100% Free Download! 100% Pass Guaranteed! Lead2pass provides 100% pass 300-101 exam questions and answers for your Cisco 300-101 exam. We provide Cisco 300-101 exam questions from Lead2pass dumps and answers for the training of 300-101 practice test. Following questions and answers are all new published by Cisco Official Exam Center: https://www.lead2pass.com/300-101.html QUESTION 341How to set up IP SLA to monitor Bandwidth between the certain limits? A.    TimerB.    FrequencyC.    ThresholdD.    Queue-limitAnswer: C QUESTION 342A network engineer is troubleshooting connectivity issues with a directly connected RIPng neighbor. Which command should directly connected RIPng neighbor adjacencies only? A.    router#show ipv6 rip next-hopsB.    router#show ip rip neighborsC.    router#show ipv6 routersD.    router#show ipv6 rip database Answer: A QUESTION 343Where are EIGRP successor routes stored? A.    In the routing table onlyB.    In the neighbor table onlyC.    In the topology table onlyD.    In the routing table and the topology tableE.    In the routing table and the neighbor table Answer: D QUESTION 344If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface? A.    The lowest IP address of any physical interfaceB.    The highest IP address of any physical interfaceC.    The lowest IP address of any logical interfaceD.    The highest IP address of any logical interface Answer: B QUESTION 345You get a call from a network administrator who tells you that he typed the following into his router: Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0 He tells you he still can't see any routes in the routing table. What configuration error did the administrator make? A.    The wildcard mask is incorrect.B.    The OSPF area is wrong.C.    The OSPF Process ID is incorrect.D.    The AS configuration is wrong. Answer: A QUESTION 346You need the IP address of the devices with which the router has established an adjacency. Also, the retransmit interval and the queue counts for the adjacent routers need to be checked. What command will display the required information? A.    show ip eigrp adjacencyB.    show ip eigrp topologyC.    show ip eigrp interfacesD.    show ip eigrp neighbor Answer: D QUESTION 347What command would you use to set EIGRP routes to be prioritized? A.    distance 100B.    distance 89C.    distance eigrp 100D.    distance eigrp 89 Answer: D QUESTION 348What is used in EIGRP metric calculation? A.    maximum delayB.    minumum delayC.    avarage delayD.    minimum interface bandwidth Answer: D QUESTION 349What configurations does PPPoE allow? (Choose 2) A.    Client and server can be configured on same nodeB.    8 clients can be configured on 1 CPEC.    Clients can reach others using DMVPNs Answer: BC QUESTION 350Congestion in the network. What is the effect on UDP? A.    Sender will have to buffer more data..B.    Receiver will have to buffer more data. Before sending packets to higher layersC.    There will be latency Answer: C QUESTION 351Which two statement about GRE tunnel interface are true? (Choose two) A.    A tunnel can be established when a source the source interface is in the up/down stateB.    A tunnel Destination must be Routable, but it can be unreachableC.    To establish a tunnel the source interface must be a loopbackD.    To Establish a tunnel the source interface must be up/up stateE.    A tunnel destination must be a physical interface that is on up/up state Answer: BD QUESTION 352Which two are characteristics of IP ACLs? (Choose two) A.    Entries are applied to traffic in the order in which they appear.B.    They support wildcard masks to limit the address bits to which entries are applies Answer: AB QUESTION 353What are 2 protocols used for user with authentication on network device? A.    CHAPB.    RadiusC.    802.1xD.    PAPE.    TACACS+ Answer: BE QUESTION 354The OSPF which type of Router CAN BE aggregated? (Choose two) A.    the ABRB.    the ASBRC.    Backbone RouterD.    Intra Router Answer: AB QUESTION 355Which two statements about route targets that are configured with VRF-Lite are true? (Choose two) A.    Route targets uniquely identify the customer routing tableB.    Route targets control the import and export of routes into a customer routing tableC.    Route targets are supported only when BGP is configuredD.    When IS-IS is configured, route targets identify the circuit level in which the customer residesE.    When BGP is configured, route targets are transmitted as BGP standard communitiesF.    Route targets allos customers to be assigned overlapping adresses Answer: BC QUESTION 356Which type of message does a device configured with the eigrp stub command send in response to EIGRP queries? A.    invalid requestB.    unavailableC.    stuck in activeD.    stub-onlyE.    rejectF.    inaccessible Answer: F QUESTION 357Drag and Drop QuestionDrag and drop each GRE feature on the left to the correct answer on right.   Answer:   QUESTION 358A Network engineer wants to configure logging to compile and send information to an external server. Which type of logging must be configured? A.    TerminalB.    SyslogC.    BufferD.    Console Answer: B QUESTION 359When unicast reverse path forwarding is configured on an interface, which action does the interface take first when it receives a packet? A.    it verifies that the source has a valid VEF adjacency.B.    It checks the egress access lists.C.    it verifies a reverse path via the FIB to the source.D.    It checks the ingress access lists. Answer: C QUESTION 360Which two among the following are used to indicate external type of route in routing table? (Choose two.) A.    D EXB.    IAC.    O E2D.    R E2E.    i L2 Answer: AC Lead2pass is the leader in 300-101 certification test questions with training materials for Cisco 300-101 exam dumps. Lead2pass Cisco training tools are constantly being revised and updated. We 100% guarantee Cisco 300-101 exam questions with quality and reliability which will help you pass Cisco 300-101 exam. 300-101 new questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDX0QwYXF1aXFINmM 2017 Cisco 300-101 exam dumps (All 470 Q&As) from Lead2pass: https://www.lead2pass.com/300-101.html [100% Exam Pass Guaranteed] --------------------------------------------------- Images: --------------------------------------------------- --------------------------------------------------- Post date: 2017-10-17 07:43:44 Post date GMT: 2017-10-17 07:43:44 Post modified date: 2017-10-17 07:43:44 Post modified date GMT: 2017-10-17 07:43:44 ____________________________________________________________________________________________ Export of Post and Page as text file has been powered by [ Universal Post Manager ] plugin from www.gconverters.com