This page was exported from Easily Pass By Training Lead2pass Latest Dumps
[
https://www.freebraindump.com
]
Export date: Fri Mar 29 4:31:39 2024 / +0000 GMT
Easily Pass 400-351 Exam With Lead2pass New Cisco 400-351 Brain Dumps: https://www.lead2pass.com/400-351.html QUESTION 31 A. The default number of attempts is 100. Answer: B QUESTION 32 A. A PTK is generated before the client roams to the target AP. Answer: BC QUESTION 33 A. PEAP with WPA2-AES is not supported with Cisco Centralized Key Management,use EAP-FAST. Answer: B QUESTION 34 A. The integer corresponds to a power level that vanes depending on the regulatory domain in which the access points are deployed Answer: AB QUESTION 35 A. Install a server certificate signed by a well-known public CA on the Radius Server Answer: A QUESTION 36 A. to allow more than 20 client associations Answer: B QUESTION 37 A. 36.0 mbps Answer: B QUESTION 38 A. multicast-uncast Answer: C QUESTION 39 A. Enable IP DHCP SNOOPING TRUST on the wireless controller port-channel interface Answer: BD QUESTION 40 A. The Ethernet port is disabled in repeater mode Answer: AD 400-351 dumps full version (PDF&VCE): https://www.lead2pass.com/400-351.html Large amount of free 400-351 exam questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDY0FaMFVrWHdXWEk
Your customer wants to configure LSCs and asks for specific information about which number to configure in the text box right next to the "Number of Attempts". Which statement is true?
B. A value of 2 means that if an AP fails to join the Cisco WLC using an LSC, the AP attempts to Join the Cisco WLC using the default certificate
C. A value of 255 means that if an AP fails to join the Cisco WLC using an LSC,the AP does not attempt to join the Cisco WLC using the default .
D. A value of 3 means that if a user fails to authenticate,the user is disconnected after three retries.
Which two statements about 802.11r are true? (choose two)
B. Non-802.11r clients cannot associate to WLANs that have 802 llr enabled on WLC AireOS code 8.0
C. 802.11r IS supported only on OPEN and WPA2 WLANs.
D. This protocol uses the four-way handshake for the key managment upon roaming.
Your customer is having wireless VoiP problems. When the Cisco 7925 phones roam from APtlo AP2,the voice drops out and comes back.The phones are set up for PEAP/WPA2-AES with CCKM to an external RADIUS server. The APs and WLAN are setup in FlexConnect mode. Which statement explains the issue ?
B. The APs have not been added to the FlexConnectgroup .
C. PEAP with WPA2-AES is not supported with Cisco Centralized Key Management,use LEAP.
D. The APs have been added to the FlexConnectgroup .
In Cisco Wireless LAN Controller .the transmit power level of an AP radio is assigned an integer value inserted of a value in mW or dBm.
Which two statements about the power levelare true (Choose two)
B. Each successive lower power level always represents 50% of the previous power level.
C. Power Ievel 1 is always the minimum power level allowed per country code setting.
D. There are always eight power levels for configuration .
Refer to the exhibit. What is the best way to resolve this issue?
B. Disable certificate checks on the client .
C. Use the certificate authority on the Cisco Identity Services Engine.
D. Install a server certificate signed by a well-known public CA on the WLC.
An autonomous AP is configured with the infrastructure -client command.
What is this command used for ?
B. to send reliable multicast traffic
C. to enable multiple VLANs to cross the bridge link
D. to allow only infrastructure device associations
Refer to the exhibit. At which rate are the multicast frames transmitted by an autonomous AP configured with these data rates, considering the client on the AP is a 802.11b client?
B. 11.0 mbps
C. 12.0 mbps
D. 5.5 mbps
E. 2 mbps
Which multicast mode is recommended when configuring Media Stream on a Cisco WLC?
B. multicast-routing
C. multicast-multicast
D. multicast-direct
Which two configuration are required on the Cisco 5760 WLC to ensure that APs will successfully join the Cisco WLC? (choose two)
B. Activate the appropnate Right-to-use AP license on the wireless LAN controller
C. Ensure that port-fast is enabled on each access point switch port
D. Ensure accurate configuration of the correct time and date on the wireless LAN controller
which two option describe implication of deploying autonomous APs in repeater mode? (choose two)
B. You can configure multiple VLANs on repeater access point
C. You should disable Cisco Aironet extensions on the parent(root) AP and on the repeater APs
D. The infrastructure SSID should be assigned to the native VLAN
Post date: 2018-05-29 03:45:42
Post date GMT: 2018-05-29 03:45:42
Post modified date: 2018-05-29 03:45:42
Post modified date GMT: 2018-05-29 03:45:42
Powered by [ Universal Post Manager ] plugin. MS Word saving format developed by gVectors Team www.gVectors.com